Agilent Technologies E8403A Guía de instalación descargar pdf (Pagina 55)

Modifying an Existing ParBERT System Setting Up ParBERT

Agilent 81250 ParBERT Installation Guide, February 2002 55

3 Plug the trigger input pod into the appropriate 16-pin socket on the

clock card, as indicated in Figure 36.

Figure 36 Clock Module Connections

4 Reattach the side cover with the screws you removed earlier (see

Figure 25 on page 48 for the location of the screws), and reinsert the

clock module into the mainframe.

5 Re-connect all cables disconnected earlier.

Call the Agilent support if you need additional probe leads. The required

part number is 16520-62102.

NOTE You need to remove the leads from the probe adapter header before

plugging them into the pod housing.

Socket for trigger

input pod

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 103 104

Installation Guide 1
Safety Summary 2
Contents 3
Setting Up ParBERT 43G 57 4
Declaration of Conformity 99 5
About this Guide 7
Contents of This Guide 8
Document History 9
Getting Started 11
ParBERT Overview 12
Mainframes 13
Controller Options 13
Software Components 19
Not Recommended Combinations 20
The ParBERT Approach 21
Basic Installation Procedure 23
ParBERT Local Configurations 23
Operating ParBERT via the LAN 26
Once You are Finished 27
Installation Prerequisites 28
Setting Up ParBERT 31
Unpacking ParBERT 32
Connecting the Peripherals 34
Setting Up a System with 35
Expander Frames 35
Placing the Mainframes 36
Expander Frame 37
Master Frame 38
1394 Links 39
Extenders 41
How to Remove a Module 44
How to Add a Module 44
LOGICAL ADDRESS 46
How to Open a Module 47
Removing a Frontend 50
Installing a Frontend 52
Hardware 56
Setting Up ParBERT 43G 57
ParBERT 43G Components 58
Setup Procedure 60
Connections of the MUX/DEMUX 61
Special Configurations 63
Clock Connections 64
43.2G Pattern 65
Generator Bundle 65
38 .. 43.2 Gb/s 65
Clock Provided by the DUT 66
Clock (675MHz 67
User Software 70
Updating the Firmware (BIOS) 72
Configuring ParBERT 76
Selecting the Operating Mode 77
Users Only) 79
Selecting the I/O Interface 80
Build Systems 81
Starting the ParBERT User 84
Software 84
How to Select the System 85
How to Get Help 88
Testing ParBERT’s Integrity 89
Connecting ParBERT to the LAN 91
Factory Default Settings 92
Configuring ParBERT for LAN 92
<your_domain> 93
<your_computer_name> 93
<your_workgroup> 93
<your_IP_addr> 94
<your_subnet> 94
<your_Gateway> 94
Problems at the Power-On 95
Selftest 95
Problems after Changing the 96
Problems with Clockgroups 97
Declaration of Conformity 100
Edition 2.1 104
81250-91010 104

Comentarios a estos manuales

Sin comentarios

Agilent Technologies E8403A Guía de instalación Pagina 55

Comentarios a estos manuales