Agilent-technologies J3972A Manual de usuario descargar pdf (Pagina 37)

Local Terminal Configuration

Probe Configuration Using a Local Terminal

Some initial configuration information must be entered into the probe before it

can communicate over the LAN telemetry network interface or serial port. The

ATM interface must be configurated before monitoring can occur.

The initial configuration for the Ethernet LAN Telemetry network (10Base-T or

100Base-TX) communication consists of the following parameters:

IP Address

Default Gateway IP Address (if required)

Subnet Mask (if required)

Autodiscovery Echo Interval

If you are configuring the optional Token-Ring LAN Telemetry interface, you

need to configure the following parameters:

Ring Speed

Ring Number

The probe uses the following configuration parameters to display time and date

information in the user interface only. The probe uses a separate internal clock to

time-stamp data collected from the network.

Date

Time

Time Zone

The initial configuration for communication over the serial port consists of the

following parameters:

Serial Port IP Address

Serial Port Subnet Mask (if required)

Serial Port Speed

Serial Port Mode

Modem Control String (if required)

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 188 189

Sin comentarios

Agilent-technologies J3972A Manual de usuario Pagina 37