Agilent Technologies 6813B Manual de usuario descargar pdf (Pagina 44)

4 - Front Panel Operation

Protection and Status Control Keys

The Protect and Status keys control the protection functions and status registers of the ac source. Refer to

Chapter 4 of the Programming guide for more information on the status registers.

Press this key to access the protection menu list.

Display Command Function

PROT:CLEAR Clear the status registers of all activated protection signals.

The fault causing a signal must be corrected or removed

before the register can be cleared.

CURR:PROT <char> Set overcurrent protection function (ON or OFF).

VOLT:PROT <value> Set the overvoltage protection level

DELAY <value> Set the time delay for activating a protection fault after

programming the output

Press this key to access the status menu list. Note that in the following list, commands

ending in ? clear the registers when they are read. For this reason the registers are read

only after you press , not when you scroll to the command

Display Command Function

*CLS Executes the clear status (*CLS) command

STATUS:PRESET Execute the STATus:PRESet command

*ESR? <value> Return Event Status register value

*STB <value> Return Status Byte register value

OPER:EVEN? <value> Return STAT:OPER:EVENT? value

OPER:COND <value> Return STAT:OPER:COND? value

QUES:EVEN? <value> Return STAT:QUES:EVENT? value

QUES:COND <value> Return STAT:QUES:COND? value

Notes:

Programmed in peak volts. (Other voltage parameters are programmed in rms volts)

value = a numeric value

char = a character string parameter

and scroll through the command list.

and scroll through the parameter list.

Protect

Enter

StatusShift

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 90 91

Sin comentarios

Agilent Technologies 6813B Manual de usuario Pagina 44