Agilent Technologies 34410A Guía de usuario descargar pdf (Pagina 102)

Remarks

You must select the limit math function (CALC:FUNC LIM) and turn on

math operations (CALC:STAT ON) before you set a limit value.

You can assign a lower limit, an upper limit (see CALCulate:LIMit:UPPer

command), or both. The lower limit must always be less than or equal to

the upper limit, even if you are using only one of the limits.

Limit crossing: If a reading is greater than the specified upper limit, bit 12

("Upper Limit Failed") is set in the Questionable Data Register, which

results in an SRQ if enabled. You can use the

STATus:QUEStionable[:EVENt]? command to read the event register. See

STATus Subsystem Introduction for further information.

The instrument clears all limits after a Factory Reset (*RST command) or

an Instrument Preset (SYSTem:PRESet command), or when the math

function or measurement function is changed.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 189 190

Sin comentarios

Agilent Technologies 34410A Guía de usuario Pagina 102