Agilent Technologies 22D Guía de usuario Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 72
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
User’s and Service Guide 2-3
Getting Started
Setting the Test Set Address Switch
Setting the Test Set Address Switch
The test set is shipped with the GPIB (HP-IB) address set to 12, which
sets the parallel address to 0 as in Figure 2-2. Refer to Chapter 3
"Controlling the Test Set and Making Measurements" for the definition
of the parallel address.
To set the GPIB address, set all five switches so that the sum of the
switches in the on or “1” position equal the desired address. In the
example below, the two switches in the “on” position are 8 and 4, thus
the GPIB address of 12.
To set the parallel address, use only the number 1 switch. Therefore
the possibilities for parallel port addressing are an address of 0 or 1.
When GPIB is used, the parallel address is ignored.
Figure 2-2 The Test Set Address Switch
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 71 72

Comentarios a estos manuales

Sin comentarios