Agilent Technologies E4400-60230 g Manual de usuario

Part Number E4400-90218Printed in USA May 2000 Supersedes February 2000Installation NoteAgilent Technologies ESG–D and ESG–DPSeries Signal GeneratorsU

10 Installation Note E4400-90218Removing Hardware (Options UN7/UND not Installed)Removing the Rear Panel1. Refer to Figure 3. Remove the 15 screws (it

Installation Note E4400-90218 114. Remove the nut (not shown) that secures the serial tag (item 9). Then remove the serial tag.5. Discard the old rea

12 Installation Note E4400-90218UN8 Installation (Options UN7/UND not Installed)Assembling and Installing the Rear Panel1. Using the 8 washers and 8 h

Installation Note E4400-90218 13Modifying the Front Panel1. Refer to Figure 5. Remove the I–INPUT (W1) and Q–INPUT (W2) BNCs from the front panel.2.

14 Installation Note E4400-90218Installing the A7 and A8 Assemblies1. Refer to Figure 6. Insert the Board Assy-Generator/1 Meg (A8) into the A14J4 mot

Installation Note E4400-90218 15Figure 6 Option UN8 (Options UN7/UND not Installed) Top ViewFigure 7 Cables W25 and W26

16 Installation Note E4400-90218UN8 Installation (Options UN7/UND Installed)Installing the A7 and A8 Assemblies1. Refer to Figure 8. If the A7 or A8 b

Installation Note E4400-90218 17Figure 8 Option UN8 (Options UN7/UND Installed) Top ViewFigure 9 Cables W25 and W26

18 Installation Note E4400-90218Completing the Installation (All Signal Generators)Installing New FirmwareThe firmware upgrade kit contains an installa

NoticeThe information contained in this document is subject to change without notice.Agilent Technologies makes no warranty of any kind with regard to

Installation Note E4400-90218 3IntroductionThis installation note covers different configurations of signal generators depending on whetherOptionUN7 o

4 Installation Note E4400-90218E4400-60170 Upgrade Kit (Add Option UN8)Use this upgrade kit to add Option UN8 Real-Time I/Q Baseband Generator with TD

Installation Note E4400-90218 524 1 0 0 Installation Note E4400-9021825b2 0 0 SMB to BNC Cable (W25 & W26) 8120-878126 1 0 0 ESG Digital Document

6 Installation Note E4400-90218Tools RequiredWARNING Before you disassemble the instrument, turn the power switch off, andunplug the instrument. Failu

Installation Note E4400-90218 7Verifying the Functionality of the Signal GeneratorThis procedure verifies that the signal generator powers up and that

8 Installation Note E4400-90218Removing the Top Chassis Cover (All Signal Generators)1. Turn the instrument’s power switch off, and unplug the instrum

Installation Note E4400-90218 9Figure 2 Top Chassis Cover Removal