Agilent Technologies FS2010 Manual de servicio descargar pdf (Pagina 367)

Agilent Signal Generators Programming Guide 359

Creating and Downloading User–Data Files

Save and Recall Instrument State Files

Perform the following steps to run the State_Files program.

1. Copy the State_Files.cs file from the CD–ROM programming examples section to the directory

where the .NET Framework is installed.

2. Change the TCPIP0 address in the program from TCPIP0::000.000.000.000 to your signal

generator’s address.

3. Save the file using the .cs file name extension.

4. Run the Command Prompt program. Start > Run > "cmd.exe". Change the directory for the

command prompt to the location where the .NET Framework was installed.

5. Type csc.exe State_Files.cs at the command prompt and then press the Enter key on the keyboard

to run the program. The following figure shows the command prompt interface.

The State_Files.cs program is listed below. You can copy this program from the examples directory on

the signal generator’s Documentation CD–ROM.

NOTE The State_Files.cs example uses the ESG in the programming code but can be used with the

PSG or Agilent MXG.

//****************************************************************************************

// FileName: State_Files.cs

// This C# example code saves and recalls signal generator instrument states. The saved

// instrument state files are written to the local computer directory computer where the

// State_Files.exe is located. This is a console application that uses DLL importing to

// allow for calls to the unmanaged Agilent IO Library VISA DLL.

1 2 ... 362 363 364 365 366 367 368 369 370 371 372 ... 395 396

Sin comentarios

Agilent Technologies FS2010 Manual de servicio Pagina 367