Agilent-technologies J3972A Manual de usuario descargar pdf (Pagina 72)

Installation

Connecting the Probe

1. Connect the probe’s AUI port, located on the rear panel, to the network with

an AUI cable. Figure 3-4 shows how to connect the probe to a 10MB/s

Ethernet network using the AUI connector.

2. Select AUI as the Physical Connector parameter from the Modify/View

Interface Values menu.

Figure 3-4: Connecting the Probe to a 10MB/s Ethernet Network

The following types of network-specific MAUs are available for connecting to the

AUI port:

Fiber-Optic MAU (Agilent 28683A) - for fiber-optic cabling

10Base-2 MAU (Agilent 28641B) - for ThinLAN cabling

NOTE

If the SQE test is available on the MAU, disable it.

Connecting to 10Base-T/100Base-TX Telemetry Networks

You can connect the probe to the network either by connecting the RJ-45

connector to a 10Base-T/100Base-TX half-duplex or full-duplex network or by

connecting the AUI connector to a 10MB/s Ethernet network.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 188 189

Sin comentarios

Agilent-technologies J3972A Manual de usuario Pagina 72