Agilent-technologies E1300B Manual de usuario descargar pdf (Pagina 148)

• ON or 1 specify that interrupt handling is to be set up for the specified

interrupt line. OFF or 0 indicate that interrupt handling of the specified

line is to be done by the operating system.

• Related Commands: DIAG:INT:ACT, DIAG:INT:PRIority[n],

DIAG:INT:RESP?

• *RST Condition: DIAG:INT:SETup[n] OFF (for all lines)

Example Setup and wait for VXI interrupt response on line 2.

DIAG:INT:PRI2 5 set priority to 5 on line 2

DIAG:INT:SETUP2 ON handle interrupt on line 2

. code which will

. initiate an action

. resulting in an interrupt

DIAG:INT:RESP? Read the acknowledge response

:INTerrupt:SETup[n]? DIAGnostic:INTerrupt:SETup[n]? Returns the current state set by

DIAG:INT:SETUP[n] < mode> , for the VXI interrupt line specified by [n] in

…SETup[n]?.

Comments •…SETup1? through …SETup7? specify the VXI interrupt lines 1

through 7.

• Sending SETup? without an [n] value specifies VXI interrupt line 1.

• If 1 is returned, interrupt handling is set up for the specified interrupt

line using the System Instrument (DIAGnostic:INTerrupt commands). If

0 is returned, interrupt handling is done by the operating system.

• Related Commands: DIAG:INT:SETup[n], DIAG:INT:PRIority[n],

DIAG:INT:ACT, DIAG:INT:RESP?

Example Determine interrupt setup for line 4.

DIAG:INT:SETUP4?

enter statement statement returns 0 or 1

DIAGnostic:INTerrupt:SETup[n]?

7-20 System Instrument Command Reference

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 243 244

Sin comentarios

Agilent-technologies E1300B Manual de usuario Pagina 148