Agilent-technologies Wireless Network Optimization Platform E6474A Manual de usuario Pagina 184

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 194
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 183
184 Agilent E6474A User’s Guide
D Permanent In-Vehicle Hardware Installation
Your system is now ready for configuring in the E6474A
Drive Test Software. Refer to the E6474A Getting Started
Guide (E6474- 90085 - which can be found in Help >
Library).
Installing the Mounting Plate
Install the receiver’s mounting plate as follows:
1 Locate a flat surface of the vehicle to which the mounting
plate can be securely attached.
2 Mark the holes for the #12 mounting screws on the
mounting surface according to the hole pattern of the
plate (refer to Figure 113 on page 185).
3 Drill the holes, using a 3/32” (2.5mm) drill bit, or the
metric equivalent that accommodates the screw.
4 Attach the mounting plate to the vehicle, using the
hardware provided.
NOTE
Do not locate your receiver near a heat source or warm location. Excessive
heat may effect performance and reliability of the receiver.
Vista de pagina 183
1 2 ... 179 180 181 182 183 184 185 186 187 188 189 ... 193 194

Comentarios a estos manuales

Sin comentarios