Agilent Technologies EasyEXPERT Guía de usuario Pagina 135

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 228
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 134
Agilent EasyEXPERT Users Guide Vol. 2, Edition 1 9-9
If You Have a Problem
When You Perform Measurement
SMU Oscillates for Negative Resistance Measurements
If the DUT has negative resistance characteristics, SMUs may oscillate. Because the
positive feedback may be configured by the DUT and the SMUs.
To solve this problem:
For voltage controlled negative resistance device
Connect G in parallel with your DUT to cancel negative resistance. To
obtain an output I-V curve, use the following equation.
IY = I - G V
For current controlled negative resistance device
Connect R in series with your DUT to cancel negative resistance. To obtain
an output I-V curve, use the following equation.
VZ = V - R I
If the resistance of the DUT is less than 1 M, you can use a series resistor
built into the SMU.
Vista de pagina 134
1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 227 228

Comentarios a estos manuales

Sin comentarios