Agilent Technologies Ininiium 9000 Guía de usuario Pagina 77

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 112
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 76
Using the Oscilloscope
To turn a channel on or off
3-41
To turn a channel on or off
To turn a channel on, click the check box next to the channel number so that
a check mark appears in the box. To turn a channel off, click the check box
again to clear it.
See figure 3-15.
If you are not using a channel, you can turn it off. This simplifies the waveform
display and also increases the display update rate. When you turn off a channel, the
current vertical scaling factor and vertical scale buttons for that channel disappear.
They re-appear when you turn the channel on.
You can also turn a channel on or off by using the Channel Setup dialog box, or by
using the front panel key for that channel.
Figure 3-15
Turning a Channel On or Off
Turn a channel off
by clicking in the
On check box until
the box is cleared
Turn a channel on
by clicking in the On
check box until a
check mark appears
Vista de pagina 76
1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 111 112

Comentarios a estos manuales

Sin comentarios