Agilent Technologies Ininiium 90000 Especificaciones descargar pdf (Pagina 32)

Infiniium DSO-X 90000A Series Oscilloscopes

Performance characteristics

Sampling model (continued)

Segmented memory Captures bursting signals at max sample rate without consuming memory during periods of inactivity

Number of segments (Up to 524,288 with option 026)

Maximum time between triggers is 562,950 seconds

Re-arm time: 4.5µs

Maximum memory depth: Up to 4 Gpts in 1/2 channel mode with option 026

Filters

Sin(x)/x Interpolation On/off selectable FIR digital filter. Digital Signal Processing

adds points between aquired data points to enhance

measurement accuracy and waveform display

Hardware Trigger

Sensitivity Internal low

Internal high

Auxiliary

Edge Trigger Bandwidth

Minimum Pulse Width Trigger

Hardware

Software (InfiniiScan)

Level Range

Internal

Auxillary

± 4 div from center screen or ± 4 Volts, whichvever is

smallest

± 5 V, also limit input signal to ± 5V

Sweep Modes

Display jitter

(displayed trigger jitter)

Trigger sources Channel 1, Channel 2, Channel 3, Channel 4, aux, and line

Trigger Modes

Edge

Edge Transition

Edge then Edge (time)

Edge then Edge (Event)

Glitch

Line

Pulse Width

Triggers on a specified slope (rising, falling or alternating between rising and falling) and voltage level on

any channel or auxiliary trigger

Trigger on rising or falling edges that cross two voltage levels in > or < the amount of time specified. Edge

transition setting from 250 ps.

The trigger is qualified by an edge. After a specified time delay between 10 ns to 10 s, a rising or falling edge

on any one selected input will generate the trigger

The trigger is qualified by an edge. After a specified delay between 1 to 16,000,000 rising or falling edges,

another rising or falling edge on any one selected input will generate the trigger.

Triggers on glitches narrower than the other pulses in your waveform by specifying a width less than your

narrowest pulse and a polarity. Triggers on glitches as narrow as 125 ps. Glitch range settings: < 250 ps to <

10 s.

Triggers on the line voltage powering the oscilloscope

Trigger on a pulse that is wider or narrower than the other pulses in your waveform by specifying a pulse

width and a polarity. Triggers on pulse widths as narrow as 125 ps. Pulse width range settings 250 ps to 10

s. Trigger point can be “end of pulse” or “time out”.

Runt Triggers on a pulse that crosses one threshold but fails to cross a second threshold before crossing the first

again. Can be time qualified with minimum setting of 250 ps.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38

Comentarios a estos manuales

Sin comentarios

Agilent Technologies Ininiium 90000 Especificaciones Pagina 32

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control Agilent Technologies Ininiium 90000