Agilent Technologies N1022A Manual de usuario descargar pdf (Pagina 40)

VoiceControl

• Hands-free scope operation

• Speaker and gender independent

• Uses simple English commands

If you’re making multi-channel

measurements on target systems

with densely packed ICs, your

hands are tied up holding probes,

making it difficult to turn knobs

and press buttons on the front

panel of your oscilloscope.

To solve this problem, Infiniium

scopes can be controlled with

VoiceControl. Using a collar-

mounted microphone, which is

included, you can control front

panel functions with the use of

voice controls (English only),

allowing hands-free operation of

the scope. VoiceControl is both

speaker and gender independent

and does not require the oscillo-

scope to be trained.

VoiceControl Functions

• Run, stop, print, autoscale,

default setup, clear screen.

• Vertical controls: volts/divi-

sion, offset, coupling, input

impedance, channel on/off.

• Horizontal controls: time/divi-

sion, delay, delayed sweep.

• Trigger controls: mode, source,

slope, sweep, coupling,

trigger level.

• Storage controls: save wave-

forms and screen images.

• Waveform measurements.

• “Undo” and “again” commands

to retract or repeat last

command.

• Help for VoiceControl.

Figure 11.1. VoiceControl allows you to control the scope hands free.

Ordering Information

Part # Description Quantity

E2635A [1] VoiceControl retrofit kit for Infiniium 548XXA Series 1

N2850A VoiceControl option for Infiniium 54830B/D 1

Series with software rev. A.02.xx or below

E2682A VoiceControl option for Infiniium 54830A/B/D 1

Series and 54850A Series with software rev. A.03.10

or higher

E2633-68704 VoiceControl upgrade kit for already purchased 1

Infiniium oscilloscopes that do not have an

“E2633A” product tag, or have a serial number

prefix less than US3919. This kit lets you add

VoiceControl software and VoiceControl hardware

(sound card, collar-mounted microphone).

Installation and calibration prices not included.

Please contact your Agilent representative for pricing.

[1] To use the retrofit kit, you must have the following minimum Infiniium configuration: 300 MHz CPU, 64 MB RAM,

Windows

98 , Version A03.50 or greater of the system software, LS-120 120 MB SuperDisk drive.

To determine if your Infiniium meets these configuration criteria, look at the back of your unit. If the serial number

of your unit starts with US3919 or higher, you meet these requirements. If there is a product tag with “E2633A,”

“E2633-68703,” or “E2633-68701,” you meet the requirements. If you do not meet the minimum requirements, you

must order an Infiniium oscilloscope performance upgrade in addition to the E2635A. Please contact your Agilent

representative for selecting the right performance upgrade for your Infiniium oscilloscope.

Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176

FAX 781.665.0780 - TestEquipmentDepot.com

1 2 ... 35 36 37 38 39 40 41 42

Comentarios a estos manuales

Sin comentarios

Agilent Technologies N1022A Manual de usuario Pagina 40

Comentarios a estos manuales

Relacionado con productos y manuales para De medición, control y control Agilent Technologies N1022A