Agilent Technologies 4294A Manual de servicio descargar pdf (Pagina 177)

100

101

Chapter 12 177

Using LAN

Controlling the Agilent 4294A

1. Chapter Title

12. Using LAN 3. Chapter Title

4. Chapter Title

5. Chapter Title

Figure 12-5 ctrl_lan.xls

In the part 1, type the version No. of WinSock API into the cell at the right to “WinSock

Version.” Determine this version No. by multiplying the major version No. by 256, then

adding this product to the minor version No. In the case of Version 1.1, for example,

256

× 1 + 1 = 257. Type the IP address of the 4294A into the cell at the right to “IP

address.” If any of these two entries is wrong, this VBA macro will never work.

In the part 2, set the 4294A’s measurement parameters, the sweep range (starting and

stopping points), the number of measurement points, the sweep type, and ON/OFF of trace

A/B split display. Clicking the Set button will set these conditions as shown in the Settings

Table; clicking the Query button will read the current settings of the 4294A. Clicking the

Clear button will clear the Settings Table.

In the part 3, basic control of the 4294A is operated. Below is described what actions each

button produces when pressed:

Preset Returns to the initial setting.

CONT Sets to continuous sweep.

HOLD Holds sweep.

SING Executes sweep once.

Trace A Sets Trace A to active trace.

Trace B Sets Trace B to active trace.

Auto Scale Executes Auto Scale.

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 517 518

Comentarios a estos manuales

Sin comentarios

Agilent Technologies 4294A Manual de servicio Pagina 177

Comentarios a estos manuales

Relacionado con productos y manuales para Multímetros Agilent Technologies 4294A