Agilent Technologies N9320A Guía de usuario descargar pdf (Pagina 28)

20 N9320A Spectrum Analyzer

2 Getting Started

Power on and Check

1 Connect the power cord. Insert the plug into a power socket

provided with a protective earth. Set the tilt adjustor for

your preference.

2 Press the line switch on the rear panel. The standby LED

(orange) will light and the spectrum analyzer is in standby

mode.

3 Press the standby switch on the front panel. The Line

LED (green) will light, and the spectrum analyzer boots up.

Self- initialization takes about 25 seconds; the spectrum

analyzer then defaults to the menu mode. After power on,

let the spectrum analyzer warm up for 45 minutes for

stabilization.

NOTE

The front panel switch is a standby switch only; it is not a power

switch. To disconnect the spectrum analyzer from the line power, shut

off the power switch on the rear panel.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 177 178

Sin comentarios

Agilent Technologies N9320A Guía de usuario Pagina 28