Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Guía de instalación descargar pdf (Pagina 125)

125

Chapter 9: Using the Pattern Generator

Set Up the Pattern Generator

For the pattern generator to output the "walking ones" to the logic

analyzer, the lower four bits of Pod 4, which is connected to the

training board through the TTL Data Pod, must be assigned to

PATGEN.

1 In the Main System window, click on the Pattern Generator, and

select Setup...

2 Select the Format tab.

3 Click on Lab1, select Rename..., and change the label name to

PATGEN.

PATGEN is short for pattern generator, and represents the pattern

generator data captured by the timing analyzer.

4 Click OK.

5 Click on the field showing the 8 channels of pod 4.

6 Select Individual... from the pop-up menu.

7 If there are asterisks ‘*’ in the PATGEN window, right-click and

hold to select ‘................’ from the pop-up menu.

This changes the bits from being assigned to the label PATGEN to

being unassigned.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 145 146

Sin comentarios

Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Guía de instalación Pagina 125