Agilent Technologies 42D Guía de usuario descargar pdf (Pagina 23)

2-3

Programming Getting Started

Initialization

To make sure the bus and all appropriate interfaces are in a known state, begin

every program with an initialization statement. HP BASIC provides a CLEAR

command which clears the interface buffer:

CLEAR 707 ! initializes the interface of the instrument

When you are using GPIB, CLEAR also resets the oscilloscope’s parser. The

parser is the program which reads in the instructions which you send it.

After clearing the interface, initialize the instrument to a preset state:

OUTPUT 707;"*RST" ! initializes the instrument to a preset

state.

Information for Initializing the Instrument

The actual commands and syntax for initializing the instrument are discussed in the

common commands section of the online Programmer’s Reference.

Refer to your controller manual and programming language reference manual for

information on initializing the interface.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 109 110

Sin comentarios

Agilent Technologies 42D Guía de usuario Pagina 23