Agilent Technologies 3070 Manual de instalación descargar pdf (Pagina 13)

Chapter 1: MS Windows System Installation Procedure: Setting Up the KVM and Support Arms

3 Install the support arms:

CAUTION

✸

Install the support arm T-piece to the front of the system. Damage may

occur during testhead rotation if the support arm T-piece is positioned to

the rear.

a Open the pod door.

b If present, pry the plastic square plug from the top of the mounting arm post.

c Unpack the support arms and the monitor and keyboard trays.

d Install the post of the support arm T-piece (E9900-10245), in the appropriate

column.

1) If the pod door is in the way, remove it by lifting it up, then out. Replace

it when done.

2) Secure the post using a 1/4-inch hex key wrench, two each cap screws

(3030-1044), and lock washers (2190-0963). For 307X, 317X and 327X

systems, use the top and middle screw holes.

e Insert the 13-cm (5-inch) extension riser (E9900-10246), into the hole of the

support arm T-piece that is farthest from the operator.

f If needed, install the square plastic cap in the top of the unused support arm

column.

Table 1-2 Install the KVM and support arms (continued)

Task Step

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 115 116

Sin comentarios

Agilent Technologies 3070 Manual de instalación Pagina 13