J-BERT N4903A High-Performance Serial BERT Data Sheet 7
Pattern generator key characteristics:
• Differential outputs for data, clocks and trigger
• Variable output voltages covering LVDS, ECL, CML
• Transitions times < 20 ps
• Clean pulses with Jitter < 9 ps pp
• High-precision delay control input to inject jitter from
an external source
• Calibrated and integrated jitter injection
(option J10, J20, both retrofitable)
• Subrate clocks for generating any reference clock
• Pattern sequencing and 32 Mbit pattern
• SSC clocks for computer buses (option J11)
Figure 12: Clean output signal. 10 Gb/s, LVDS levels.
Figure 13: Pattern generator setup screen with graphical dis-
play of signal levels.
Table 1: Output characteristics for J-BERT N4903A generator.
All timing parameters are measured at ECL levels
Range of operation 150 Mb/s to 12.5 Gb/s (opt.
C13) Can be programmed up to
13.5 Gb/s.
150 Mb/s to 7 Gb/s (opt. C07)
< 620 MHz only with external
clock.
Frequency accuracy ± 15 ppm typical
Format NRZ, normal or inverted
Amplitude/Resolution 0.10 V to 1.8 V, 5 mV steps
Adresses LVDS, CML, PECL,
ECL (terminated to 1.3 V/
0 V/-2 V), low voltage CMOS
Output voltage window -- 2.0 V to +3.0 V
Predefined levels ECL, PECL (3.3 V), LVDS, CML
Transition times
(20% to 80%) < 20 ps
(10% to 90%)
2)
< 25 ps
Jitter 9 ps pp typical with disabled jitter
sources
Clock/data delay range ± 0.75 ns in 100 fs steps
External termination -- 2 V to +3 V
voltage
3)
Crossing point Adjustable 20% to 80% typical to
emulate duty cycle distortions
Single error inject Adds single errors on demand
Fixed error inject Fixed error ratios of 1 error in
10
n
bits, n = 3, 4, 5, 6, 7, 8, 9
Interface
1)
Differential or single-ended,
DC coupled, 50Ω
Connector 2.4 mm female
1)
Unused outputs must be terminated with 50Ω to GND.
2)
At 10 Gb/s and 7 Gb/s
3)
For positive termination voltage or termination to GND, exter-
nal termination voltage must be less than 3 V below VOH. For
negative termination voltage, external termination voltage must
be less than 2 V below VOH. External termination voltage must
be less than 3 V above VOL.
Figure 11: Generator connectors on front panel.
Data Output (DATA OUT)
Specifications
Pattern Generator Specifications
(320 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales