Agilent Technologies U4154A Guía de instalación descargar pdf (Pagina 14)

14 U4154A Logic Analyzer Installation Guide

1 Introduction

Pod Connector Cables

The Agilent U4201A 90- pin pod connector cable is used to

connect the U4154A module with the probes which then

connect to the DUT/SUT. The module connector at one end

of the cable is installed in the relevant pod input on the

front panel of the Logic Analyzer module. The other end of

the cable is connected to the probes.

The following figure displays a 90- pin U4201A cable followed

by a figure displaying this cable connected to the Agilent

Differential Soft Touch and Flying Lead Set probes.

Figure 5 U4201A 90-pin Pod Connector Cable

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

Sin comentarios

Agilent Technologies U4154A Guía de instalación Pagina 14