Agilent Technologies U4154A Guía de instalación descargar pdf (Pagina 37)

Setting up the Hardware for U4154A 2

U4154A Logic Analyzer Installation Guide 37

Step 7 - Connect the Probes to the DUT

As per the testing scenario, use the appropriate probe from

the probing solutions available with Agilent.

You can use:

• Flying- lead probe sets. This is called general purpose

probing. In this probing, connect probe connectors to

individual IC pins or test points.

• Elastomeric probe adapter and 1/4 flex adapter products

available for several types of QFP packages. This is called

QFP package probing. In this probing, connect to all the

pins of a specific QFP package.

• Soft Touch Connectorless Logic Analyzer Probes. This is

called target connector probing or soft- touch

connectorless probing. This probing removes the

connector that is traditionally attached to the target

board and replaces it with an array of probe pads.

• Processor or bus- specific probes. These are called analysis

probes and are available for many processors and buses.

To connect and set up a probe, follow the instructions in the

User’s Guide that accompanies the probe.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 67 68

Sin comentarios

Agilent Technologies U4154A Guía de instalación Pagina 37