Agilent Technologies N1911A Manual de usuario descargar pdf (Pagina 8)

Demonstration Preparation

The following instruments and soft-

ware are required in order to perform

these demonstrations:

• Agilent ESG E4438C or MXG N5182A

• P-Series power meter N1911A or

N1912A

• P-Series wideband power sensor

N1921A or N1922A

• Signal Studio software N7615A/B

for Mobile WiMAX or N7613A/B for

ﬁ xed WiMAX.

Update your instrument’s ﬁ rmware and

software to the latest version available

at:

• www.agilent.com/ﬁ nd/esg

• www.agilent.com/ﬁ nd/mxg

• www.agilent.com/ﬁ nd/wideband_

powermeters

• www.agilent.com/ﬁ nd/signalstudio

This demonstration focuses on mobile

WiMAX (OFDMA) thus Signal Studio

N7615A/B will be installed in the

controller PC.

Product type Model number Required option

Agilent ESG Vector

Signal Generator

E4438C ﬁ rmware

revision C.04.60 or

later

• 503 or 506 — frequency

range

• 601 or 602 — baseband

generator

Agilent MXG Vector

Signal Generator

N5182A ﬁ rmware

revision 1.10 or later

• 503 or 506 — frequency

range

• 651 or 652 — baseband

generator

P-Series Power Meter N1911A or N1912A

ﬁ rmware revision

A.03.01 or later

P-Series Wideband

Power Sensor

N1921A or N1922A

Signal Studio for 802.16

WiMAX software

N7615B Version

1.8.2.0 or later

Controller PC for Signal

Studio for 802.16

WiMAX

Install N7615B to generate

and download the signal

waveform into ESG or MXG

via GPIB or LAN (TCP/IP).

Refer to on-line documen-

tation for installation and

setup.

Connecting the PC, ESG and P-Series

Instructions

1. Connect a PC (loaded with the Signal Studio N7615A/B for 802.16 WiMAX

software and Agilent I/O Libraries Suite) to the E4438C ESG via GPIB or

LAN. The setup procedure in this guide assumes that LAN interface is

used.

2. Set up the Client with I/O Conﬁ guration of Agilent I/O Libraries using LAN

interface from Signal Studio.

3. Make necessary connections on the ESG and P-Series power meter and

sensors as shown in Figure 8. Perform the following steps in the next page

to interconnect ESG and P-Series power meter and sensors.

Figure 8 P-Series and ESG conﬁ guration diagram

GPIB or LAN

on ESG back

panel

RF Out

ESG

N1921A

N1912A

Channel A

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

Comentarios a estos manuales

Sin comentarios

Agilent Technologies N1911A Manual de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Multímetros Agilent Technologies N1911A