Agilent Technologies E4438C Guía de instalación descargar pdf (Pagina 33)

Operation Verification

FM Accuracy Check

Chapter 3 29

FM Accuracy Check

Connect the Test Equipment

Figure 3-4 FM Accuracy Equipment Setup

Configure the Signal Generator

1. Press Preset.

2. Press

FM/ΦM > FM Off On. The FM annunciator is displayed.

3. Press

FM Rate. Enter 1 using the numeric keypad and press the kHz terminator softkey.

4. Press

FM Dev. Enter 100 using the numeric keypad and press the kHz terminator softkey.

5. Press

Amplitude. Enter 7 using the numeric keypad and press the dBm terminator softkey.

6. Ensure that the MOD ON annunciator is displayed. If it is not, press

Mod On/Off.

7. Press

RF On/Off. The RF ON annunciator is displayed.

Configure the Measuring Receiver

1. Reset the measuring receiver.

2. Set the measuring receiver to FM mode.

3. Turn on Peak+ detector.

4. Turn on the 300 Hz high-pass filter.

5. Turn on the 3 kHz low-pass filter.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 55 56

Sin comentarios

Agilent Technologies E4438C Guía de instalación Pagina 33