Agilent-technologies Signal Analyzer N9030a Manual de usuario descargar pdf (Pagina 110)

3 Programming the Analyzer

IEEE 488.2 Common Commands

Remote Command

*TRG

Example *TRG Triggers the instrument to take a sweep or start a measurement, depending on the current

instrument settings.

Notes See related command :INITiate:IMMediate.

Initial S/W Revision Prior to A.02.00

Self Test Query

This query performs the internal self-test routines and returns a number indicating the success of

the testing. A zero is returned if the test is successful, 1 if it fails.

Remote Command

*TST?

Example *TST? Runs the self-test routines and returns 0=passed, 1=some part failed.

Initial S/W Revision Prior to A.02.00

Wait-to-Continue

This command causes the instrument to wait until all overlapped commands are completed before

executing any additional commands. There is no query form for the command.

Remote Command

*WAI

Example INIT:CONT OFF; INIT;*WAI Sets the instrument to single sweep. Starts a sweep and waits for its

completion.

Status Bits/OPC

dependencies

Not global to all remote ports or front panel. *OPC only considers operation that was initiated on

the same port as the *OPC command was issued from.

Initial S/W Revision Prior to A.02.00

110 Remote Language Compatibility Measurement Application Reference

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 145 146

Sin comentarios

Agilent-technologies Signal Analyzer N9030a Manual de usuario Pagina 110