Agilent Technologies 8935 Series Manual de usuario descargar pdf (Pagina 261)

Chapter 8 261

IBASIC Controller

Method #3. Developing Programs Using Word Processor on a PC (Least Preferred)

Sending ASCII Text Files over RS-232 with ProComm

Communications Software

Set up the ProComm terminal emulator software on the PC as covered

in “Setting Up ProComm Revision 2.4.3 on your PC” on page 236. On

the Test Set, enter and run the ASCII_DN download program in the

IBASIC controller. When the prompt Ready to receive ASCII file

data is displayed on the Test Set, make the following settings in the

ProComm terminal emulator on the PC:

NOTE

The ProComm terminal emulator views the file transfer as sending the

file from the PC “up” to the Test Set. This is opposite to the direction

used by the previous HyperTerminal example. Therefore, with

ProComm an ASCII “upload” transfer is used.

1. Press Alt+F10 to display the ProComm help screen.

2. Press Alt+P to display the SETUP MENU.

3. Select item 6: ASCII TRANSFER SETUP.

4. Set Echo locally: NO.

5. Expand blank lines: YES.

6. Pace character: 0.

7. Character pacing: 15.

8. Line pacing: 10.

9. CR translation: NONE, LF.

10.Translation: NONE (This is important since the default setting will

strip line feeds and this will cause the transfer to never begin).

11.Select the Escape key to exit setup mode and return to the main

screen.

12.Press Alt F10 to access the help menu.

13.To begin sending the file, select PgUp.

14.In the UPLOAD screen, select 7 ASCII protocol.

15.Run the ASCII_DN download program on the Test Set.

16.When the Test Set displays Ready to receive ASCII file data,

press Enter on the PC to begin the transfer. At this point, each line of

the program will rapidly scroll across the screen of the Test Set.

When the transfer is finished, the download program will display

Down load of ASCII file complete., and the program file will be

stored on the PC card in the TEMP-CODE file.

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 328 329

Sin comentarios

Agilent Technologies 8935 Series Manual de usuario Pagina 261