Agilent Technologies U1231A Guía de usuario descargar pdf (Pagina 91)

Multimeter Features 3

Freezing the Display (Trig Hold-Log and Auto Hold-Log)

U1231A/U1232A/U1233A User’s Guide 73

Figure 3-6 Auto Hold-Log display

Press and hold for more than 1 second to exit this

mode.

Changing the default Auto Hold-Log variation count

1 Press and hold while powering on the multimeter to

enter the Setup menu.

2 Ensure that the annunciator is shown on the

display.

3 Press or to edit the variation count value shown

on the display.

4 Press to save the changes. Press and hold until

the multimeter restarts.

NOTE

• The Auto Hold-Log operation monitors the input signal and updates the

display and, if enabled, emits a beep whenever a new stable

measurement is detected. The multimeter is ready to update the

display once the variation of the reading exceed the setting of the

variation count.

• The annunciator will flash while attempting to acquire a stable

reading.

Max

Min

NOTE

If the reading value is unable to reach a stable state (when exceeding the

preset variation), the reading value will not be updated.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 132 133

Sin comentarios

Agilent Technologies U1231A Guía de usuario Pagina 91