lpErrorDoc.txt
Cannot restore specified cal from backup because of a file error.
-313 Calibration memory lost; Cannot store cal to backup: {name}err={value}
Cannot store specified cal to backup because of a file error.
-313 Calibration memory lost; Cannot store cal: {name}err={value}
Cannot store specified cal because of a file error.
-313 Calibration memory lost; Error occurred while trying to load data from
previous internal IQ calibration. {name}
An expected file was not found while trying to load internal IQ
calibration data.
-313 Calibration memory lost; Previous Internal IQ calibration data is
invalid. Data has been removed. A new user IQ calibration is
recommended.
An expected file was not found while trying to load internal IQ
calibration data. All other data has been removed. A new cal should
be performed.
-310 System error
*** No documentation ***
-310 System error; Arb generation failed. File System failed to access
required file.
There was a problem opening, reading or writing to the specified
file.
-310 System error; Automatic reboot performed due to exception vector
#{value} at PC 0x%06X
An exception occurred at the instruction address. This is a
internal firmware error. Currently not supported.
-310 System error; Cal in use, cannot delete: {name}
Calibration file cannot be deleted since it is currently in use.
Error caused by diagnostic command.
-310 System error; Cannot change manual point until list mode error
condition cleared.
An error is keeping the sweep/list from being able to set the
frequency and/or power. Until the problem is addressed, the manual
point cannot be changed.
-310 System error; Could not create percent complete window semaphore.
When trying to initialize a percent complete Window the needed
semaphore could not be created. Report this error to Agilent
Technologies.
-310 System error; Could not limit frequency settings. Please preset.
Based on the current frequency settings (multiplier, offset, etc.)
the signal generator cannot successfully limit the frequency.
Preset the signal generator to insure the firmware will return to a
Page 6
(220 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales