Agilent Technologies E1345A Manual de usuario descargar pdf (Pagina 56)

Relay Multiplexer Command Reference 57

OUTPut

The OUTPut subsystem enables or disables the "Trig Out" port of the

E1300/E1301 Mainframe.

Subsystem Syntax OUTPut

[:STATe] <

state>

[:STATe]?

[:STATe]

OUTPut[:STATe] <state> enables/disables the "Trig Out" port on the rear panel of

the E1300A/E1301A Mainframe.

OUTPut[:STATe] ON|1 enables the port and

OUTPut[:STATe] OFF|0 disables the port.

Parameters

Comments • Enabling "Trig Out" Port: When enabled, the "Trig Out" is pulsed each time

a channel is closed during scanning. When disabled, the "Trig Out" is not

pulsed.

• Output Pulse: The pulse is a + 5 V negative-going pulse.

• "Trig Out" Port Shared by Switchboxes: When enabled, the "Trig Out" may

be pulsed by any switchbox each time a channel is closed in a switchbox

during scanning. To disable the output for a specific switchbox, send the

OUTPut[:STATe] OFF or OUTPut[:STATe] 0 command for that switchbox.

• Related Commands: [ROUTE:]SCAN, TRIGger:SOURce

• *RST Condition: OUTPut[:STATe] OFF (port disabled)

Example Enabling "Trig Out" Port

OUTP ON

Enables "Trig Out" port for pulse output.

[:STATe]?

OUTPut[:STATe]? queries the present state of the "Trig Out" port. The command

returns

1 if the port is enabled, or 0 if disabled.

Example Query "Trig Out" Port State

OUTP ON

Enables "Trig Out" port for pulse output.

OUTP:STAT?

Query port enable state.

Parameter Name Parameter Type Range of Values

state>

boolean 0 |1|ON|OFF

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 92 93

Sin comentarios

Agilent Technologies E1345A Manual de usuario Pagina 56