Agilent Technologies Weather Radio 1680 Manual de usuario Pagina 115

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 174
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 114
115
Chapter 6: Replacing Assemblies
1680A,AD-series disassembly/assembly
7 Reverse this procedure to install the chassis into the sleeve.
When reassembling, check the following:
all assemblies are properly installed before installing the chassis into the sleeve.
ensure all exposed cables are dressed properly so the sleeve does not cause any
damage to the cables.
To remove the acquisition board
1 Do the procedure "To remove the chassis from the sleeve".
2 Turn the chassis upside down.
3 Disconnect the IEEE 1394 cable from the acquisition board.
4 Using a Torx T-10 screwdriver, remove five screws that secure the probe
shroud to the rear panel of the logic analyzer.
5 Using a Torx T-10 screwdriver, remove one screw that secures the
acquisition board to the chassis (center of the acquisition board).
Vista de pagina 114
1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 173 174

Comentarios a estos manuales

Sin comentarios