Agilent Technologies Weather Radio 1680 Manual de usuario descargar pdf (Pagina 136)

136

Chapter 6: Replacing Assemblies

1690A,AD-series disassembly/assembly

To remove the acquisition board

1 Do the following procedures:

To remove the chassis from the sleeve

To remove the fascia

2 Using a Torx T-10 screwdriver, remove one screw that secures the

acquisition board to the deck.

3 Using a Torx T-10 screwdriver, remove five screws that secure the probe

shroud to the logic analyzer front panel.

4 Slide the acquisition board out of the logic analyzer front panel.

Steps to remove the probe shroud from the acquisition board.

1 Using a hex screwdriver, remove two hex nuts from the acquisition board

trigger BNC connectors.

2 Using a Torx T-10 screwdriver, remove five screws that secure the probe

shroud to the acquisition board.

Reverse this procedure to install the acquisition board

If the probe shroud requires replacing, then the probe shroud label (part number

01690-94302) must also be ordered and installed on the replacement probe

shroud.

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 173 174

Sin comentarios

Agilent Technologies Weather Radio 1680 Manual de usuario Pagina 136