Agilent Technologies Ininiium 90000 Especificaciones descargar pdf (Pagina 101)

Chapter 5: Replacing Assemblies

To remove and replace the on/off board

101

Figure 5-18

This figure shows the other left hand side tab for the control panel faceplate. This view is with the oscilloscope turned on its

side and looking at this tab from underneath the instrument.

To replace the front panel assembly, reverse the above procedure. Suggestion: When

you get to the part where you have to snap the tabs located on the control panel

faceplate back into the chassis, it is best to snap the faceplate and the assembly together

first before trying to attach them back to the chassis via these tabs. Once they are

attached together, snap down the right hand side tabs first and then the left hand tabs

second.

To remove and replace the on/off board

Use this procedure to remove and replace the on/off board. When necessary, refer to other

removal procedures.

Remove the front panel bezel (directions in the previous section).

Remove the one Torx T10 screw from the on/off board (Figure 5-19).

Figure 5-19

Pull the board out a little so you can see the cables connected behind it (Figure 5-20).

Disconnect these cables and then take the board off.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 147 148

Sin comentarios

Agilent Technologies Ininiium 90000 Especificaciones Pagina 101