Agilent Technologies Ininiium 90000 Especificaciones descargar pdf (Pagina 104)

Chapter 5: Replacing Assemblies

To remove and replace the touch screen, the front deck, and the controller assembly

104

To remove and replace the touch screen, the front deck, and the

controller assembly

Use this procedure to disassemble and reassemble the keyboard, touch screen, and flat-panel

display. When necessary, refer to other removal procedures. The graphics in this chapter are

representative of the oscilloscope at the time of this printing. Your unit may look different.

Disconnect the power cable and remove the cover, top plate, and bottom plate.

Remove the front panel bezel and front panel circuit assembly from the chassis.

Remove the two Torx T20 screw attaching the touch screen to the front deck of the

chassis that are located along the left hand side of the screen (Figure 5-22).

Figure 5-22

Disconnect the three cables that are attached to the screen (one is connected to the

back of the lower left hand corner of the screen, one is connected to the back of the

upper right hand corner of the screen, and the last one is connected to the right edge

of the screen) and the copper shielding (Figure 5-23) located in the upper right hand

corner of the screen.

Figure 5-23

Pull touch screen off.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 147 148

Sin comentarios

Agilent Technologies Ininiium 90000 Especificaciones Pagina 104