Agilent Technologies Ininiium 90000 Especificaciones descargar pdf (Pagina 124)

Chapter 5: Replacing Assemblies

To remove and replace the power cord

124

To remove and replace the power cord

Use this procedure to remove and replace the power cord. When necessary, refer to other

removal procedures. The graphics in this chapter are representative of the oscilloscope at the

time of this printing. Your unit may look different.

Disconnect the power cable and remove the cover and top plate.

Unplug the power cable from the 12V power supply (refer to Figure 5-52 for the location

of this connection).

Unscrew the power cord connector from rear panel (Torx T10 screws) - see Figure 5-54.

Figure 5-54

Remove the ground screw (Torx T10) on right side of hard drive (Figure 5-55).

Figure 5-55

Pull the power cord out of the instrument.

To replace the power cord, reverse these directions.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 147 148

Sin comentarios

Agilent Technologies Ininiium 90000 Especificaciones Pagina 124