Agilent Technologies Ininiium 90000 Especificaciones descargar pdf (Pagina 112)

Chapter 5: Replacing Assemblies

To remove the backplane assembly from the acquisition assemblies

112

To remove the backplane assembly from the acquisition assemblies

Remove the entire acquisition/backplane assembly as described in the previous

section.

Remove the four Torx T20 screws (two per acquisition assembly) on the side of the

backplane assembly (Figure 5-37).

Figure 5-37

Gently pry on the sheet metal portions to separate the backplane assembly from each

of the acquisition assemblies.

Remove the Torx T10 screws to remove each of the boards from their respective

subassembly chassis (Figure 5-38).

Figure 5-38

To reassemble the backplane/acquisition assembly, reverse these instructions.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 147 148

Sin comentarios

Agilent Technologies Ininiium 90000 Especificaciones Pagina 112