Agilent Technologies 53230A Especificaciones descargar pdf (Pagina 181)

Chapter 3 Replacing Assemblies

To Remove the Processor Board

Assembly-Level Service Guide 181

To Remove the Processor Board

1 Remove the cover and rear bezel as described previously.

2 Turn the chassis upside down. On the bottom of the motherboard,

remove the T10 TORX screw that secures the smaller Processor

printed circuit board to the motherboard (see Figure 3-6).

Figure 3-6. Processor PC Board

NOTE For re-assembly, note how the left rear corner of the Processor

board fits into its slot (above the small plastic standoff inside the

slot) to hold the board horizontal.

3 Press the two tabs securing the edge connector of the Processor

board to release the board.

4 Remove the Processor board carefully from its connector and set

it aside in a safe location on the ESD mat.

5 To re-install the Processor board, reverse the above procedure.

Slot

T10 Motherboard

Processor

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 259 260

Sin comentarios

Agilent Technologies 53230A Especificaciones Pagina 181