Agilent Technologies Agilent 8166A Manual de instrucciones descargar pdf (Pagina 142)

Measurement Operations & Settings Signal Generation – The SOURce Subsystem

142 Agilent 8163A/B, 8164A/B & 8166A/B Mainframes, Fifth Edition

command:

[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:REPeat

syntax: [:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:REPeat<wsp><mode>

description: Sets the repeat mode. Applies in stopped-sweep and manual-sweep modes.

parameters: ONEWay:

TWOWay:

Every stepped or continuous sweep cycle starts at the start wavelength of the

sweep and ends at the stop wavelength of the sweep

Every odd stepped sweep cycle starts at the start wavelength of the sweep, and

every even stepped sweep cycle starts at the stop wavelength of the sweep.

Set the start and stop wavelength of the sweep using

“[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STARt” on page 144 and

“[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STOP” on page 144 respec-

tively.

response: none

example: wav:swe:rep twow

affects: All tunable laser modules

command:

[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:REPeat?

syntax: [:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:REPeat?

description: Returns the repeat mode.

parameters: none

response: ONEWay:

TWOWay:

Every stepped or continuous sweep cycle starts at the start wavelength of the

sweep and ends at the stop wavelength of the sweep

Every odd stepped sweep cycle starts at the start wavelength of the sweep,

and every even stepped sweep cycle starts at the stop wavelength of the

sweep.

Set the start and stop wavelength of the sweep using

“[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STARt” on page 144 and

“[:SOURce[n]][:CHANnel[m]]:WAVelength:SWEep:STOP” on page 144 re-

spectively.

example: wav:swe:rep? → ONEW<END>

affects: All tunable laser modules

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 273 274

Sin comentarios

Agilent Technologies Agilent 8166A Manual de instrucciones Pagina 142