Agilent Technologies C-Size VXIbus Systems Manual de usuario descargar pdf (Pagina 73)

EPC7-4 : Configure the Command Module to Work with the EPC7

When you are using a Command Module in your system to interpret SCPI

commands for the register-based instruments, you must configure your

Command Module as a non-slot 0 device. The steps involved are as follows:

• Set the Command Module’s Logical Address

• Set the Command Module’s Servant Area

• Set the Command Module’s Primary GPIB Address

• Disable the Command Module’s slot 0 and System Controller

Capability

In a VXIbus system with an EPC7 computer and Agilent E1406A

Command Module, it is recommended that the EPC7 functions as the

resource manger and slot 0 device, and that the E1406A Command Module

be a servant of the EPC7. The resource manager and slot 0 functions and

commander/servant hierarchy concepts are covered in Appendix A, "Terms

and Definitions."

If you need to assign selected instruments to report to the Command

Module in the Commader/Servant Hierarchy, see the "Agilent RADI-EPC7

Embedded Computer" section in Procedure 5, "Apply Power."

C-Size Configuration Guide Setting Up an Embedded RADI-EPC7 Computer 2-55

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 177 178

Sin comentarios

Agilent Technologies C-Size VXIbus Systems Manual de usuario Pagina 73