
104
Chapter 6: Connecting Accessories
38-pin Single-ended Probe (E5346A for analyzers with 40-pin pod connectors)
38-pin Single-ended Probe (E5346A for analyzers with 40-pin pod
connectors)
NOTE: For all Agilent logic analyzers except 16517A, 16518A, 16760A, and
16753/54/55/56A.
The 38-pin probe provides a convenient way to connect two Agilent
Technologies logic analyzer probe cables to a small area of a target
system. The Agilent Technologies E5346A probe has isolation networks
in the cable end that connects to the 38-pin AMP MICTOR (Matched
Impedance ConnecTOR) connector.
40-pin
Logic Analyzer
Pod
Probe Cable
Shroud
Equivalent Load
370
ohm
Signal
Ground
Includes lo
ic analyzer and MICTOR connector.
9pF3pF
100k
ohm
mp "MICTOR 38"
Connector
AMP "MICTOR 38" Connector Pinout
(Top View)
v
e
n
o
+5VDC
GND DC
CLK
D15
D14
D13
D12
D11
D10
D9
D8
D7
D6
D5
D4
D3
D2
D1
D0
1
3
5
7
9
11
13
15
17
19
21
23
25
27
29
31
33
35
37
O
d
d
P
o
d
CLK
D15
D14
D13
D12
D11
D10
D9
D8
D7
D6
D5
D4
D3
D2
D1
D0
2
4
6
8
10
12
14
16
18
20
22
24
26
28
30
32
34
36
38
Do not connect
Do not connect
Note:
DO NOT
connect these pins to
a +5V supply in the
target system!
+5V is supplied
from the logic analyzer
to provide power for
analysis probes and
demo boards.
Comentarios a estos manuales