Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Guía de instalación descargar pdf (Pagina 106)

106

Chapter 6: Connecting Accessories

100-pin Single-ended Probe (E5378A for analyzers with 90-pin pod connectors)

100-pin Single-ended Probe (E5378A for analyzers with 90-pin pod

connectors)

NOTE: For use with Agilent logic analyzer modules 16760A, 16753A, 16754A,

16755A, and 16756A.

The Agilent E5378A is a 34-channel, single-ended, 100-pin probe capable of

capturing data up to the rated maximum state (synchronous) analysis clock

rates of all the supported analyzers, with signal amplitudes as small as 250 mV

peak-to-peak. One E5378A probe is required for a 16760A module and two are

required to support all the inputs on a 16753/54/55/56A module. A 100-pin

connector must be installed on you target system board.

90-pin

Logic Analyzer

Pods

34-channel

Single-ended

100-pin Probe

Shroud

100-Pin

Connector

1.5pF

150ohm

Signal

Ground

20k

0.7pF

Equivalent Load

0.75V

Includes logic analyzer and 100-pin connector

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 149 150

Sin comentarios

Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Guía de instalación Pagina 106