Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Guía de instalación descargar pdf (Pagina 81)

Chapter 4: Installing Oscilloscope Measurement Modules

16533/34A Oscilloscope Module (single or multi-card modules)

10 If you are only calibrating one card set the PROTECTED/

UNPROTECTED switch back to PROTECTED.

11 For multi-card modules, leave the switch set to UNPROTECTED and

continue to Step 4 to perform reconfiguration.

Step 4

Reconfigure multi-card modules

A multicard module should contain either all 16533A or 16534A cards.

1 After calibrating each card individually (following the procedures

beginning on page 72) and before applying power to the mainframe,

connect the module cables.

a Beginning with the top-most card, connect the ECL EXT TRIG OUT

to the ECL EXT TRIG IN of the card immediately below. Use the

master/expander trigger cable included with the accessory kit of

each card.

PROTECTED

UNPROTECTED

If only calibrating one

card set protect.

Master/expander

trigger cables

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 149 150

Sin comentarios

Agilent Technologies 16700 SERIES LOGIC ANALYSIS SYSTEM 16700 Guía de instalación Pagina 81