Agilent Technologies B2902 Manual de servicio descargar pdf (Pagina 177)

Agilent B2900 SCPI Command Reference, Edition 2 4- 55

Subsystem Commands

:OUTPut:FILTer[:LPASs]:TCONstant

Sets the time constant instead of setting the cutoff frequency of the output filter. This

command setting is ignored if the automatic filter function is enabled by the

:OUTPut:FILTer:AUTO command.

Syntax :OUTPut[c]:FILTer[:LPASs]:TCONstant time_constant

:OUTPut[c]:FILTer[:LPASs]:TCONstant? [time_constant]

Parameter time_constant value (5 s to 5 ms)|MINimum|MAXimum| DEFault.

Parameter data type is NRf+. Query does not support

time_constant=value. If you specify the value less than MIN or

greater than MAX, time is automatically set to MIN or MAX.

The time constant can be expressed by the following formula, using the cutoff

frequency set by the

:OUTPut:FILTer[:LPASs]:FREQuency command. So the last

command setting is effective for both time_constant and frequency.

time_constant= 1/(2    frequency)

Query response time_constant <newline>

time_constant returns the present setting of the cutoff frequency. If a parameter is

specified, time_constant returns the value assigned to DEF, MIN, or MAX.

Response data type is NR3.

Example :OUTP:FILT:TCON 1E-6

:OUTP2:FILT:LPAS:TCON?

:OUTPut:HCAPacitance[:STATe]

Enables or disables the high capacitance mode. This mode is effective for high

capacitive DUT.

Syntax :OUTPut[c]:HCAPacitance[:STATe] mode

:OUTPut[c]:HCAPacitance[:STATe]?

Parameter mode 1|ON|0|OFF (default). Parameter data type is boolean.

mode=1 or ON enables the high capacitance mode.

mode=0 or OFF disables the high capacitance mode.

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 325 326

Sin comentarios

Agilent Technologies B2902 Manual de servicio Pagina 177