Agilent Technologies E6640A EXM Manual de servicio descargar pdf (Pagina 120)

120 Chapter 9

Sequence Setup Commands

Programming Analyzer Sequences (Parameter-Specific Commands)

Sequence Setup Commands

8: Instrument Gain Type

NOTE This sequence parameter is used by some Agilent models for which Auto Set RF Levels

can be on or off. For E6640A, Auto Set RF Levels is always on, and the test set

automatically selects this setting for the acquisition, so this parameter is ignored by the

sequencer.

9: Transition Time

For a description of this parameter, see “9: Transition Time” on page 26. The parameter-specific

commands are described below.

SCPI Command

To set the transition time as an individual value:

[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:TIME:

TRANsition <time>

:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:TIME:

TRANsition?

To set the transition time as an array:

[:SENSe]:LSEQuencer:LIST:SETup:TIME:TRANsition

<time>,<time>,<time>,…

[:SENSe]:LSEQuencer:LIST:SETup:TIME:TRANsition?

The array form of the command is used to make a different setting for each

acquisition in the sequence (the number of array values must match the

number of acquisitions; otherwise a "settings conflict" error will occur).

SCPI Examples :LSEQ:ACQ2:SET:TIME:TRAN 10ms

:LSEQ:ACQ2:SET:TIME:TRAN?

:LSEQ:LIST:SET:TIME:TRAN 500us,1ms,2ms

:LSEQ:LIST:SET:TIME:TRAN?

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 339 340

Sin comentarios

Agilent Technologies E6640A EXM Manual de servicio Pagina 120