Agilent Technologies ENA Series Manual de instrucciones descargar pdf (Pagina 126)

126 Chapter 4

Troubleshooting

To configure the A20 Digital Motherboard and BIOS

Change Supervisor Password

A password needs to be entered to execute the BIOS setup utility. If a password has not

been assigned in the E5061A/E5062A, set the password using this BIOS setup utility as

follows.

a. Select "Security" using keys at the BIOS Setup Utility main menu and press

key.

b. Select “Set Supervisor password” using keys and press key.

c. Enter the password of "e506xa". Never set another password.

d. Press key.

e. If a message of "New supervisor password installed. Press any key to continue" is

displayed, press key.

Save & Exit Setup

When you want to change and save a BIOS option, Select "Exit" using keys at the

BIOS Setup Utility main menu and press key. Select “Save CMOS to Flash” using

and press key. Then select “Exit Saving Changes” using and press

key. A message of "SAVE to CMOS and EXIT (Y/N)?" is displayed. Press and

keys.

The BIOS setup utility is closed after the current settings are saved.

Exit Without Saving

If you cancel the changes in the BIOS option settings, select "Exit Discarding Change"

using keys at the Exit Menu and press key. Then, a message of "Quit

Without Saving (Y/N)?" is displayed. Press and keys.

The BIOS setup utility is closed without saving the current settings.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 250 251

Sin comentarios

Agilent Technologies ENA Series Manual de instrucciones Pagina 126