Agilent Technologies 1100 Series Manual de usuario Pagina 23

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 76
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 22
23
Installing your System
Installing the Manual Injector and 1100 series HPLC modules
6 Connect the position-sensor cable to the start cable (see Figure 6).
7 Connect the start cable to an APG-remote connector at the rear of one of the
modules.
8 Connect the CAN-bus cable for the inter-modular communication.
9 Connect the LAN cross-over cable to the detectors interface board (JetDirect
card).
10 Connect the power cords (AC) to the 1100 modules line input.
Figure 6 Installing the Start Cable (rear view of 1100 system)
Position-sensor (start)
cable
APG remote connector
See Figure 7 on page 24
AC power
AC power
LAN to PC
Pump
VW detector
CAN cable
Vista de pagina 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 75 76

Comentarios a estos manuales

Sin comentarios