Agilent Technologies 1100 Series Manual de usuario descargar pdf (Pagina 32)

Installing your System

Installing the LAN Communication

Your instrument HPLC system is operated via a standard LAN crossover

connection between the Value Solution ChemStation PC and the 1100

detector (VWD). You must ensure proper communication between the PC

and the analytical instruments. The communication uses the TCP/IP

protocol. For the configuration of the JetDirect card, that is used to connect

the analytical instrument to the LAN, the Boot Strap protocol is used, which

requires a Bootp Server.

NOTE The TCP/IP protocol and the Bootp Server program are already factory

pre-installed.

Configuring the CAG Bootp Server Program

NOTE Assure that the VW detector (with JetDirect card installed and connected to

the PC) is powered off.

1 The CAG Bootp Server program is placed in the start-up group and

automatically is started during the boot process of the PC. It’s minimized and

located in the task bar.

2 Open the Bootp Server window by clicking on it in the task bar.

3 Now turn on the VW detector on the LAN and view the Bootp Server window.

After 2 - 10 seconds the Bootp Server will display the request from the

JetDirect card with the hardware (MAC) address (this information is also

stored in the file trace.txt in the bootp server directory, if Log to Disk is

enabled), see Figure 13.

The MAC or hardware address of the JetDirect card is a world wide unique

identifier. No other network device will have the same hardware address.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 75 76

Sin comentarios

Agilent Technologies 1100 Series Manual de usuario Pagina 32