Agilent Technologies J3916A Manual de usuario descargar pdf (Pagina 125)

Download New Firmware

Downloading Firmware using a Networked PC and a Terminal

105

Verify the following before you start the download procedure.

The probe is connected to the network.

The IP address, subnet mask, and default gateway of the probe are

configured correctly.

A terminal (or a PC running terminal emulator software) is attached to the

probe’s RS-232 port (using a null modem cable). Configure the

communication link for 8 bits per character, 1 stop bit, no parity, Xon/Xoff

handshaking, and a baud rate of 9600.

You will also need the IP address of the networked PC.

Use the following procedure to download firmware to the probe from the

networked PC using a terminal:

CAUTION

The probe executes a cold start if you press the CONFIG button twice within one

second. If this happens, wait for the cold start to be completed (about 45 seconds)

and then press the CONFIG button again to enter the configuration mode.

1. Press the CONFIG button on the back of the probe once. The probe’s Main

Menu, as shown in Figure 6-3, is displayed on the console.

NOTE

The probe’s CONFIG button is recessed. This requires the use of a narrow,

pointed object (like a pen) to press the CONFIG button.

A warm start or cold start is completed when the Fault LED goes off. If traffic is

present, the Activity LED flashes to show traffic.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 178 179

Sin comentarios

Agilent Technologies J3916A Manual de usuario Pagina 125