Agilent Technologies J3916A Manual de usuario descargar pdf (Pagina 73)

Installation

Connecting the Probe

Connecting to Token-Ring Telemetry Networks

The Token-Ring option must be installed to connect the probe to a Token-Ring

telemetry network.

CAUTION

Connecting the Token-Ring interface to your network when the interface is

configured to the wrong network speed (4Mb/16Mb) can cause

disruption of all

traffic on your network

and it will prevent the probe from properly inserting into

the ring.

You can configure the Token-Ring Speed from the Modify/View Configuration

Values Menu. The probe is configured with a default setting for 16Mbps

networks. Refer to “Token-Ring Telemetry Interface Configuration” on page 29

for information on changing this parameter.

You connect the Token-Ring interface to your network by using the appropriate

cables. The probe has both RJ-45 and DB-9 connectors on the rear panel for

connecting to Token-Ring networks. Figure 3-6 shows the back panel with the

Token-Ring option installed.

Figure 3-5: Connecting the Probe to a 10Base-T/100Base-T Network

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 178 179

Sin comentarios

Agilent Technologies J3916A Manual de usuario Pagina 73