
To transfer the setup of an individual step
The HP 54653A ScopeLink software 2.0 can transfer the setup of an
individual step from the oscilloscope to the PC and store it as a file. The file
can then be used as a backup of the individual step. To restore the individual
step, simply send the file back to the oscilloscope. This file can also be used
as a part of a test library. A test sequence can be constructed by using
individual steps and mask templates stored in the PC.
1 Select Data Transfer from the menu bar, then select Test
Automation.
2 When the Test Automation Panel appears, check the box labelled
Step for transferring an individual step.
3 Select the box trailing the label number, and enter the step number
that you want to work on.
Valid step numbers are from 1 to 100.
4 Enter the filename into the Filename box.
The extension of the filename must be ".SLS", which is automatically
appended to the filename if no extension is given.
5 To retrieve the setup of an individual step, check the box labelled
Receive.
To restore the setup of an individual step, check the box labelled
Send.
6 Select Okay to start the transfer. To return to the main menu, select
Quit.
HP 54653A ScopeLink 2.0 Software
To transfer the setup of an individual step
113
Comentarios a estos manuales