Agilent Technologies HP 54601B Guía de usuario descargar pdf (Pagina 61)

To document a single step

A single step can be documented by displaying the contents of the step on

the screen and performing a print screen to the printer. This does not

require the use of an instrument controller.

1 Set up the interface to output to a printer.

See "To configure the interface" in this chapter for details on setting up the

output for a printer.

2 Press Print/Utility twice.

3 Press the Sequence Admin softkey.

4 Press the Define Sequence softkey.

5 To change the step number to be documented, press the Step softkey,

or turn the knob closest to the Cursors key, until the desired step

number appears under the

Step softkey.

6 Press the Show Step softkey.

7 Press Print/Utility twice to return to the root level of the

softkey menu tree.

8 Press the Print Screen softkey to dump the current screen to the

hard copy device.

Single step documentation hint

The mask shown on the screen is 25% of its original size. Small details of the

mask may be omitted due to insufficient resolution. For full size documentation

of the mask, the HP 54653A ScopeLink software 2.0 and a PC or compatible

computer is required. See chapter 6, "HP 54653A ScopeLink 2.0 Software" for

information on performing the documentation.

Operating the Test Automation Module

To document a single step

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 122 123

Sin comentarios

Agilent Technologies HP 54601B Guía de usuario Pagina 61